Best Jack Stands for Tesla Model 3 (2026): 5 Pairs Compared

Compared on paper

Specifications are manufacturer rated, as published on each listing and collected 29 October 2026. Where a listing contradicts itself, both figures are shown.

How the points were given

Each stand is scored on performance, build, value, safety and warranty, with the weights published on our How We Pick page. None of the five listings states a safety certification, so all score zero on safety, and three state a 1-year warranty while two state no warranty term. The ranking turns on capacity, height range, locking design and saddle shape.

Scores run from 9.2 to 9.8: each product’s point total is placed on that range, so more points always means a higher score. Safety counts only for powered gear or where the listing states safety features; where it does not apply, the score is taken over the remaining 90 points.

What the listings tell you

We compared five jack stands. Four are rated at 3 tons and one at 4 tons, and three state a 1-year warranty while two state none. Two listings give a full height range, one gives a minimum height only, and one title-only listing gives no height figures at all. Every stand here is a pair, so the capacity figure covers the pair.

Buying guide: best jack stands for tesla model 3

Capacity first, then height

Capacity is the headline figure, but height range decides whether the stand fits under the car at all. The BESTOOL pair is rated at 4 tons and 8,000 lb, above the 3 ton and 6,000 lb rating on the ARCAN, Jack Boss and BIG RED pairs, while the YELLOW JACKET title lists 3 tons and 6600 lb capacity. The ARCAN pair covers 11.62 to 17.5 inches, the Jack Boss pair covers 11.3 to 16.8 inches, and the BIG RED pair covers a shorter range. The BESTOOL listing gives a minimum height of 11.06 inches with no maximum stated, so check the top of its range on the listing before buying. A stand that cannot reach the lift height is useless no matter how much weight it holds.

Locking and saddle shape

Locking is what keeps the height you set. The ARCAN pair uses a counterweighted pawl that locks in place, the Jack Boss and BIG RED pairs use double locking with a removable locking support pin, and the BESTOOL pair uses dual locking pins. Saddle shape matters just as much: the ARCAN saddle is large and contoured with locating lugs, the Jack Boss and BIG RED saddles are large with a broad contact surface, and the BESTOOL saddles are flat rubber, which the listing says protects the vehicle frame better than a curved post. For a car with flat lift points, a flat rubber saddle is the gentler contact. Check the saddle against the lift points in the owner’s manual before the first lift.

Stands are not jacks

A jack lifts the car, and stands hold it: never get under a vehicle supported only by a jack. The stands here are rated for holding a lifted vehicle during inspection, maintenance and repair, not for lifting it. Place rated stands on solid, level ground, set them at matching heights, and check the owner’s manual lift points before going under the car. The Jack Boss listing also warns its stands are not suggested for big pickups, trucks or SUVs with a chassis higher than 16 inches, which is a reminder to match the stand to the vehicle, not just to the weight.

Read the listing twice

Listings contradict themselves, and the bullets win over the spec table. The ARCAN bullets give a height range of 11.62 to 17.5 inches, while its spec table lists a minimum height of 5 inches, so use the bullets figure. The YELLOW JACKET listing is title only, so its 3 ton and 6600 lb figures come from the title with no height, weight or warranty figures stated. When a figure you need is missing, treat it as unstated and check the listing again rather than guessing. For more garage gear, browse our jacks and stands hub.

Garage Fit Check

• Never get under a vehicle supported only by a jack: use rated stands on solid, level ground.
• Check the owner’s manual lift points and match the saddle shape to them before lifting.
• Compare the height range with the lift height: the ARCAN pair reaches 17.5 inches and the Jack Boss pair reaches 16.8 inches.
• Set both stands at the same height and confirm the locking pin or pawl is engaged before going under the car.
• Confirm the warranty on the listing: three pairs here state a 1-year warranty and two state no warranty term.

FAQ: garage tools

What capacity jack stands do I need for a sedan?

Every pair here is rated at 3 tons or more, with the BESTOOL pair rated at 4 tons and 8,000 lb. Check the vehicle weight and the owner’s manual, and use stands rated above it.

Can I use jack stands on a Tesla Model 3?

The listings here state no Tesla fitment, so check the owner’s manual lift points and the saddle height against the car before buying. The BESTOOL flat rubber saddles are listed as protecting the vehicle frame, and the ARCAN saddle has locating lugs for positioning.

Do jack stands lift the car?

No. A jack lifts the vehicle and the stands hold it at height for inspection, maintenance and repair. Never get under a vehicle supported only by a jack.

What height range should I look for?

Match the range to the lift height. The ARCAN pair covers 11.62 to 17.5 inches, the Jack Boss pair covers 11.3 to 16.8 inches, and the BIG RED pair covers a shorter range.

Related: our jacks and stands hub and our car lifts hub.