Best Push Broom Rack (2026): 4 Racks Compared

After a weekend brake job, the push broom usually ends up leaning in a corner, sliding down the wall every time the garage door shakes. A wall rack ends that slide, and this guide compares clamp-style holders and a steel tine rack for the best push broom rack in a home garage, judged by slots, hooks, handle fit, mounting and stated capacity.

GarageToolHQ earns a commission when you buy through links on this page, at no extra cost to you. Read our affiliate disclosure.

Picks for the garage

#	Product	Shop Score	Buy
1	IMILLET 2 Pack Broom Holder Wall Mount Stainless	9.7/10	Buy on Amazon
2	2 Pack Mop Broom Holder Wall Mount 4 Racks 5 Hooks	9.6/10	Buy on Amazon
3	voze 5 Racks and 4 Hooks Mop and Broom Holder Wall	9.6/10	Buy on Amazon
4	Gempler's Extra Long Tool Rack for Shovels	9.6/10	Buy on Amazon

1

IMILLET 2 Pack Broom Holder Wall Mount Stainless

IMILLET·9.7/10 Shop Score

i

The Shop Score runs from 9.2 to 9.8 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A pair of 304 stainless steel holders with 5 slots and 4 hooks each, for screws or self-adhesive mounting.

Check price on Amazon

Pros

• Two holders in the pack, each with 5 slots and 4 hooks
• 304 stainless steel clamps with non-slip silicone rollers
• Holds handles from 0.5 to 1.5 inch in diameter
• Mounting holes fit standard 16 inch stud spacing

Cons

• Spec table lists 200 pounds while the bullets list 100 lb on screws and 33 lb on adhesive
• No warranty term is stated
• No safety certification is stated
• Self-adhesive mounting holds far less than screws

2

2 Pack Mop Broom Holder Wall Mount 4 Racks 5 Hooks

ZONGOOL·9.6/10 Shop Score

i

The Shop Score runs from 9.2 to 9.8 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A pair of black 304 stainless steel holders with 4 slots and 5 hooks each, with spring-loaded rubber rollers.

Check price on Amazon

Pros

• Two holders in the pack, each with 4 slots and 5 hooks
• 304 stainless steel with a black lacquered finish
• Rubber rollers grip handles from 0.7 to 1.3 inch
• Screws or self-adhesive mounting, hardware included

Cons

• No weight capacity is stated
• No warranty term is stated
• No safety certification is stated
• One fewer slot per holder than the 5-slot racks here

3

voze 5 Racks and 4 Hooks Mop and Broom Holder Wall

voze·9.6/10 Shop Score

i

The Shop Score runs from 9.2 to 9.8 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A single 304 stainless steel holder with 5 slots and 4 hooks, for adhesive or screw mounting.

Check price on Amazon

Pros

• 5 slots and 4 hooks on one rail
• 304 stainless steel, rust-proof per the listing
• Screw mounting holds up to 50 pounds per the bullets
• Adhesive mounting needs no drilling

Cons

• Single holder, not a pair
• Adhesive mounting holds about 20 pounds, less than screws
• No handle diameter range is stated
• No warranty term is stated

4

Gempler's Extra Long Tool Rack for Shovels

Gempler's·9.6/10 Shop Score

i

The Shop Score runs from 9.2 to 9.8 and weighs performance (35%), build (25%), value (25%), safety (10%, where it applies) and warranty (5%), using only what the manufacturer and the listing publish. How we pick ›

A welded 16-gauge steel tine rack for shovels, spades, rakes and brooms, with tines angled slightly upward.

Check price on Amazon

Pros

• 16-gauge steel welded to a base, then powder-coated
• Tines are 20 inches long and angled so tools do not slide off
• Back plate measures 3-1/2 by 4-1/2 inches with two 3/8-inch mounting holes
• Holds brooms, shovels, spades, hoses, rakes and extension cords per the listing

Cons

• No weight capacity is stated
• No tine count is stated
• No warranty term is stated
• No safety certification is stated

Compared on paper

These numbers are the tool makers’ rated figures, as their listings print them on 29 October 2026. Where a listing contradicts itself, both figures are shown.

How the points were given

Each rack is scored on performance, build, value, safety and warranty, with the weights published on our How We Pick page. None of the four listings states a safety certification or a warranty term, so all score zero on safety and warranty, and the ranking turns on slots, hooks, handle fit, mounting and stated capacity.

We map each tool’s weighted total onto a 9.2 minimum and 9.8 maximum in a straight line, so the point order and score order match. Only powered tools, or tools with stated safety features, get safety points. Everything else is rated out of 90.

What the listings tell you

We compared four wall racks. Three are stainless steel clamp holders with slots and hooks, and one is a welded steel tine rack. Two sell as pairs and two as singles. Two state a handle diameter range and two do not, and only one states a screw-mount capacity above 50 pounds. None states a warranty term or a safety certification, so check the mounting and capacity figures on the listing before buying.

Buying guide: best push broom rack

Clamps or tines

Clamp holders grip each handle in a slot, so a broom stays put even when the wall shakes. The IMILLET, ZONGOOL and voze holders all use that design, with rollers or grippers that close around the handle. The Gempler’s rack works the other way: tools rest on steel tines angled slightly upward, which suits long tools like shovels and rakes but gives no grip on any single handle. Pick clamps when every tool needs its own slot, and tines when tools get grabbed and returned all day.

Count slots and hooks

Slots hold handles, hooks hold everything else: dustpans, brushes, cords and small tools. The IMILLET and voze holders give 5 slots and 4 hooks each, while the ZONGOOL pair gives 4 slots and 5 hooks each, so the ZONGOOL suits a wall with more hanging tools than clamped handles. A pair doubles both counts, which matters when the rack must clear a whole corner of brooms, mops, rakes and shovels. Count what actually leans on the wall today before choosing a slot count.

Mounting: screws or adhesive

Three holders offer both mounting methods, and the choice sets the capacity. The IMILLET listing puts screws at 100 lb and adhesive at 33 lb, and the voze listing puts screws at 50 pounds and adhesive at about 20 pounds. Adhesive suits smooth walls and renters who want no drilling, while screws suit rough walls and heavier loads. The voze listing also says to wait 48 hours after sticking the adhesive rail before it holds firmly. The Gempler’s rack mounts with screws through two holes in its back plate.

Check the handle fit

A clamp only works when the handle fits its grip range. The IMILLET clamps hold handles from 0.5 to 1.5 inch in diameter, and the ZONGOOL rollers hold handles from 0.7 to 1.3 inch, so measure the widest handle on the wall before ordering. The voze listing says its grippers hold large and small handles but states no range, and the Gempler’s tines have no grip range at all, since tools rest on tines spaced 1-1/2 inches apart. When in doubt, the wider stated range is the safer pick.

Garage Fit Check

• Measure the wall space first: the IMILLET mounting holes fit standard 16 inch stud spacing, so check the studs before drilling.
• Match the mounting to the wall: adhesive suits smooth walls, while screws suit rough walls and outdoor use per the voze listing.
• Plan by the weaker capacity figure: adhesive holds 33 lb on the IMILLET and about 20 pounds on the voze, well below their screw figures.
• Check handle diameters against the stated grip ranges, and check tine spacing on the Gempler’s rack before hanging long tools.
• Confirm the listing states no warranty term and no safety certification, so there is no maker backup to fall back on.

FAQ: garage tools

What is a push broom rack?

A wall-mounted rack that holds a push broom and similar long-handled tools off the floor, either in clamps that grip each handle or on tines that the tools rest on.

Do adhesive mounts hold a push broom?

Yes, within their stated limits: the IMILLET listing puts adhesive at 33 lb and the voze listing at about 20 pounds, so a single broom is fine but a full load of tools belongs on screws.

What handle sizes fit these racks?

The IMILLET clamps hold handles from 0.5 to 1.5 inch in diameter, and the ZONGOOL rollers hold handles from 0.7 to 1.3 inch. The voze listing states no range, so measure handles before ordering it.

Can one rack hold a push broom and a mop?

Yes. Every clamp holder here takes brooms, mops and similar handles in its slots, and the hooks take dustpans and small tools, so one rail can clear a whole cleaning corner.

Related: our garage upgrades hub, our tool storage hub.