Best Floor Jack for GMC Sierra (2026)
Four floor jacks for GMC Sierra work, compared by capacity, lift range, saddle reach, safety features and warranty.
On this page
Top picks at a glance
As an Amazon Associate we earn from qualifying purchases.
- 1
Best OverallLARBANKE 3 Ton Jack9.6/10View on Amazon - 2
Highest LiftBIG RED T83006 Jack9.5/10View on Amazon - 3
Dual PistonBonnlo 3 Ton Jack9.5/10View on Amazon
A tire rotation in the driveway turns on the moment the jack slides under the frame, the saddle meets the lift point, and the truck rises steady enough for stands to take over. This guide answers best floor jack for gmc sierra by comparing the jacks on the figures that decide a truck job: capacity, lift range, saddle reach, safety features and warranty.
For a Sierra, the deciding figures are capacity, maximum lift and saddle reach: the picks here run from a low profile 2.87 inch minimum to a high maximum lift, with 3 ton capacities on the top three and a 2 ton pick last.
GarageToolHQ earns a commission when you buy through links on this page, at no extra cost to you. Read our affiliate disclosure.
Quick picks
- Best Overall LARBANKE 3 Ton Jack: 3 ton capacity with a 2.87 inch minimum, dual pistons and load limiting protection. Check price on Amazon
- Highest Lift BIG RED T83006 Jack: High maximum lift with an extra long saddle neck for higher vehicles. Check price on Amazon
- Dual Piston Bonnlo 3 Ton Jack: Dual pistons with a 20.1 inch maximum and a 1 year manufacturer warranty. Check price on Amazon
The picks
3 Ton Hydraulic 2.87"-19.69" Floor Jack,Dual
A 3 ton low profile floor jack with dual pistons, a 2.87 to 19.69 inch lifting range and a large rubber saddle, built from carbon steel.
Pros
- Dual piston pump for faster lifting to full height
- Low 2.87 inch minimum for low clearance work
- Load limiting protection against overload
- 360 degree swivel casters and removable handle for storage
Cons
- No warranty term is stated
- 70 lb weight to move and store
- Spec table lists car and SUV only, while bullets add trucks
- 19.69 inch maximum below the BIG RED pick here
Bonnlo 3 Ton Low Profile Floor Jack,Lifting Range
A 3 ton low profile floor jack with dual pistons, a 2.95 to 20.1 inch lifting range and 360 degree swivel front casters, in alloy steel.
Pros
- Dual pistons for quick, smooth lifting
- 20.1 inch maximum for higher vehicles
- 1 year manufacturer warranty
- 360 degree swivel front casters for positioning
Cons
- No safety bypass or overload protection is stated
- No weight is stated in the spec table
- Compatible types list sedan, SUV and van, with no truck named in the spec table
- 2.95 inch minimum is higher than the LARBANKE minimum here
BIG RED Hydraulic Trolley Service/Floor Jack
A 3 ton steel trolley jack with a 5-7/8 to 20-7/8 in range and an extra-long saddle neck for SUVs and trucks.
Pros
- 20-7/8 in top lift, among the highest here
- Extra-long saddle neck for taller vehicles
- 36 lb, light for a 3 ton steel jack
- Safety bypass against overloading
Cons
- 5-7/8 in start, too tall for low cars
- Single piston pump
- No safety standard stated
- 24.5 in handle is short
DNA Motoring TOOLS-00234 Low Profile Hydraulic
A 2-ton (4,000 lb) black alloy steel trolley jack with a 5.1 to 13-inch lift range and built-in overload protection.
Pros
- 2-ton (4,000 lb) lifting capacity for everyday passenger cars
- Dependable safety release valve protects against overloading
- Alloy steel body with rear swivel casters for mobility
- Compact dimensions of 10 x 19 x 8 inches store easily
Cons
- No warranty term is stated on the listing
- Title states 5.1 inches min height while spec table states 13 centimeters
- Item weight is not stated on the listing
- No ASME PASE certification stated
Compare the picks
| Model | Shop Score | Capacity | Lift range | Saddle and wheels | Warranty |
|---|---|---|---|---|---|
| LARBANKE 3 Ton Jack | 9.6/10 | 3 ton (6600 lbs) | 2.87 to 19.69 inches | Rubber saddle, 360 degree swivel casters | Not stated |
| BIG RED T83006 Jack | 9.5/10 | 3 ton (6,000 lb) | Higher lift range | Extra long saddle neck, steel and swivel casters | Limited 1 year |
| Bonnlo 3 Ton Jack | 9.5/10 | 3 ton (6,600 lbs) | 2.95 to 20.1 inches | Swivel front casters | 1 year |
| DNA 2 Ton Jack | 9.4/10 | 2 ton (4000 lbs) | 5.1 to 13 inches | Not stated | Not stated |
Specifications are manufacturer rated, as published on each listing and collected 25 October 2026. Shop Score cells show the raw total.
How we scored them
Each jack is scored on performance, build, value, safety and warranty, with safety points only where a listing states a safety feature and warranty points only where a term is stated. No listing here states an ASME PASE listing, so safety points here come from stated protection features alone, not from a certification.
| Product | Shop Score | Perf. /35 | Build /25 | Value /25 | Safety /10 | Warranty /5 |
|---|---|---|---|---|---|---|
| LARBANKE 3 Ton Jack | 9.6 | 32 | 21 | 21 | 5 | 0 |
| Bonnlo 3 Ton Jack | 9.5 | 29 | 20 | 20 | 0 | 2 |
Scores run from 9.2 to 9.8: each product’s point total is placed on that range, so more points always means a higher score.
What the listings tell you
The listings here state capacities from 2 ton to 3 ton and lift ranges from 5.1 to 13 inches up to a higher lift range. Two listings state a 1 year warranty term, and two state a safety feature, load limiting protection on the LARBANKE pick and a safety bypass system on the BIG RED pick. Two listings give no weight figure at all, and the DNA listing gives only a title, so its card stays short and its score stays last.
How to pick the best floor jack for gmc sierra
Capacity for a truck
The 3 ton picks here cover truck work better than the 2 ton pick, which sits last for that reason. LARBANKE and Bonnlo both list 3 ton capacity, LARBANKE at 6600 lbs and Bonnlo at 6,600 lbs, while BIG RED lists 3 ton at 6,000 lb and DNA lists 2 ton at 4000 lbs. A jack lifts for the job, it does not hold the truck: stands do that part.
Lift range and saddle height
Minimum saddle height decides whether the jack slides under a low frame, and maximum height decides whether it reaches a truck lift point. LARBANKE starts at 2.87 inches and Bonnlo at 2.95 inches, both low profile figures, while BIG RED starts higher and reaches the highest maximum here with an extra long saddle neck. DNA stops at 13 inches, which limits it to lower lifts.
Safety on stands
Never get under a vehicle on a jack alone: lift with the jack, set rated stands on solid, level ground, and follow the owner’s manual lift points. That rule applies to every pick here, whatever its capacity or maximum height. Check the lift point before the first lift, and keep the work on level ground.
Wheels, handle and storage
Swivel casters decide how easily a jack moves into place: LARBANKE lists 2 large steel front casters and 2 360 degree swivel casters, BIG RED lists 2 large steel casters and 2 360 degree swivel casters, and Bonnlo lists 360 degree swivel front casters. LARBANKE adds a removable handle that saves storage space, and BIG RED lists a 24.5 inch handle. Only LARBANKE states a weight, 70 lb, so allow for a heavy jack when planning storage for the other picks.
A jack is for lifting, not holding. Never work under a vehicle supported only by a jack: set it on rated jack stands, on solid, level ground, at the manufacturer's lift points, chock the wheels, and give the car a firm shake before you go under. Read our Safety Disclaimer.
Garage Fit Check
- Check floor space for a 29.13 by 13.38 inch jack footprint before the first job.
- Check the saddle point in the owner’s manual before lifting.
- Set rated stands on solid, level ground before going under the truck.
- Check that the maximum lift covers the job: the DNA pick stops at 13 inches.
- Store the handle off the jack where it fits: the LARBANKE handle removes for storage.
Frequently Asked Questions
What capacity floor jack do I need for a GMC Sierra?
The 3 ton picks here are the ones to compare for truck work, with capacities of 6600 lbs on the LARBANKE pick and 6,600 lbs on the Bonnlo pick, against 6,000 lb on the BIG RED pick. The 2 ton pick sits last because its 4000 lbs capacity and 13 inch maximum sit below the rest. Check the lift points in the owner’s manual and use rated stands.
How high does a floor jack need to lift for a Sierra?
It depends on the job and the lift point, but the picks here reach 19.69 inches, 20.1 inches and a higher maximum on the top three, with the DNA pick stopping at 13 inches. The BIG RED pick’s extra long saddle neck helps on higher vehicles. Measure the lift point height before choosing, and never rely on the jack alone.
Can a low profile jack lift a truck?
Yes, where the listing capacity and range cover the job: the LARBANKE pick is low profile at a 2.87 inch minimum and still lifts 3 ton, and the Bonnlo pick starts at 2.95 inches with the same capacity. Low profile describes the minimum height, not a lower capacity. The DNA pick is also low profile, but at 2 ton and 13 inches it sits last here.
Do I need jack stands with a floor jack?
Yes. Never get under a vehicle on a jack alone: lift with the jack, then set rated stands on solid, level ground and follow the owner’s manual lift points. The jack lifts, the stands hold. That rule applies to every pick here, whatever its capacity.
What is the difference between the LARBANKE and Bonnlo jacks?
Both are 3 ton dual piston jacks, but LARBANKE starts lower at 2.87 inches against 2.95 inches, and Bonnlo reaches higher at 20.1 inches against 19.69 inches. LARBANKE states load limiting protection, while Bonnlo states a 1 year manufacturer warranty and LARBANKE states none. Bonnlo is alloy steel and LARBANKE is carbon steel.
Related: the best jack stands for home garage, the best floor jack for Toyota 4Runner, the jacks and stands hub. Also see our best floor jack for oil changes. Also see our heavy duty vs standard floor jack. Also see our floor jack vs car lift.
