V Belt Measurement Tool: How to Size a V-Belt
A v belt measurement tool reads the outside circumference of a V-belt so you can order the right replacement, with gauges that cover A…
Cole Brennan
How to Put in Air Filter: Steps and Gear
Open the air box, swap the old filter for the new one and close it up, with four engine filters compared by fit, life…
Types of Battery Terminals: Post, Side and Top
Quick-release connectors, copper cable lugs, military-spec terminals and top-post terminals compared by size, wire fit and warranty.
How to Clean Air Filter Car: Spray, Rinse, Dry and Oil
How to clean a car air filter with a cleaner and oil kit: spray, rinse, dry and re-oil, and which kit handles each step.
Oxygen Sensor Socket Size: Which One to Buy
Most oxygen sensors take a 7/8 in (22mm) socket, with 27mm and 29mm sizes for other sensors, compared across four socket sets, chasers included.
TIG Welder Set Up: Connections, Gas and Settings
TIG welder set up in order: connect the torch, fit the consumables, set the voltage, pick the mode for the metal, and connect the…
How to Etch Concrete Before Garage Floor Coating
How to etch a garage floor before coating it: clean and degrease, apply an etcher to open the surface profile, rinse, dry, then roll…
Radiator Flush DIY: Steps and Supplies Needed
A rust remover, a flush gun, a cleaner additive and a service kit for a DIY radiator flush, compared by size, use and warranty.
Stud Welder Dent Repair Kit: How It Works
A stud welder dent repair kit welds small studs to a dented steel or aluminum panel so a slide hammer can pull the metal…
Low Cost Plasma Cutter: What to Look For
Dual voltage, cut thickness, duty cycle and air supply: the numbers that decide a low cost plasma cutter, with 4 cutters scored.