Car Ramp Dimensions: Size Chart
Car ramp dimensions change with the job: a low-profile maintenance ramp and a long curb ramp measure very differently, so match length, width, lift height and capacity to the car and the task.
On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
2 Pack Hydraulic Car Service Ramps9.7/10View on Amazon - 2
APlusLift HW-8S 8000LB 4-Post Storage Service Car Lift 3 Year9.6/10View on Amazon - 3
Auto Dynasty Car Ramps for Oil Changes9.6/10View on Amazon
An oil change starts with getting the front of the car up off the floor, and the ramp is the part that has to fit the car, the garage floor and the job all at once. Car ramp dimensions are not one standard size: the low-profile ramp here, built for routine maintenance, is short and shallow, while the curb ramp here, built to bridge a step, is long and wide, so the right size depends on the job and the car.
GarageToolHQ earns a commission when you buy through links on our product pages, at no extra cost to you. Read our affiliate disclosure.
Below: what each measurement means, a size chart for both ramps, how to measure for the right fit, and the answers to the questions owners ask most.
VEVOR Car Driveway Rubber Curb Ramp
A 2-pack of rubber curb ramps, 48.8 in long with a 2.6 in rise and a stated 33,000 lb load capacity, with reflective safety strips.
Pros
- 33,000 lb load capacity stated in the title, with reinforced ribs and a cross-pattern design
- 48.8 in long and 16.1 in wide, sized for garage ramps, curbs and uneven ground
- Rubber build listed as sunlight-resistant and weatherproof, and will not crack or warp after sun or rain exposure
- Reflective safety strips, a textured surface and drainage channels
Cons
- Title states 33,000 lbs while the bullets state 15 tons
- No warranty term is stated in the listing
- Built for curbs and thresholds, not for lifting a car for an oil change
- Needs pre-drilled holes and expansion screws to fix in place
MaxxHaul 50516 4,400 lb. Capacity Low Profile Car
A low-profile plastic car ramp rated at 4,400 lb with a 2.5 in maximum lift height and a 9.05 degree loading angle.
Pros
- 4,400 lb maximum capacity, 2,200 lb per ramp
- 2.5 in maximum lift height with a 9.05 degree loading angle for low-clearance cars
- Honeycomb channels make removing dirt or debris easier and stop moisture building up
- 90-day warranty stated
Cons
- Title says 2-count and pack of 1 in the same line, and the spec table lists 1 item
- Only 2.5 in of lift, so it suits routine maintenance rather than jobs needing more clearance
- 90-day warranty is short
- No safety certification or anti-slip surface is stated
Car Ramp Dimensions: What Each Measurement Means
Several measurements describe a car ramp. The MaxxHaul 50516 is 27 in long with a 9.05 degree loading angle, which the maker lists for low-clearance cars. Width is the track the tyre sits on, and the VEVOR curb ramp is 16.1 in wide across a 48.8 in length. Height and lift are not the same figure: the VEVOR rises 2.6 in, while the MaxxHaul gives a maximum lift height of 2.5 in from a 3 in tall ramp. Capacity is the weight the ramp is rated to hold: the MaxxHaul is rated at 4,400 lb, or 2,200 lb per ramp, and the VEVOR title states 33,000 lb while its bullets state 15 tons.
Capacity needs care: the figure that matters is the rating per ramp, because each ramp carries its own wheel. The MaxxHaul states 4,400 lb for the set and 2,200 lb per ramp. The VEVOR listing does not state whether its stated capacity is per ramp or for the pair, so confirm the per-ramp figure before loading a heavy vehicle.
Car Ramp Size Chart
The two ramps measure very differently, which is what makes the comparison useful.
| Ramp | Length | Width | Rise / lift | Capacity |
|---|---|---|---|---|
| VEVOR Rubber Curb Ramp | 48.8 in | 16.1 in | 2.6 in rise | 33,000 lb (title) |
| MaxxHaul 50516 Ramps | 27 in | 7-3/4 in | 2.5 in lift | 4,400 lb |
The chart shows the trade-off: the curb ramp is the long, wide option for bridging a step, while the maintenance ramp is the compact option for routine work under a car.
How to Measure for Car Ramp Dimensions
- Measure the rise the job needs. An oil change needs enough lift to reach the drain plug and filter: the MaxxHaul gives 2.5 in of lift. The VEVOR 2.6 in rise is the height of a curb ramp, not lift for work under a car.
- Check the width against the tyre. Compare the tyre width with the ramp width: 16.1 in on the VEVOR, 7-3/4 in on the MaxxHaul.
- Check the loading angle for a low car. A low front bumper can catch on a steep ramp: the MaxxHaul lists a 9.05 degree loading angle for low-clearance cars.
- Match capacity per ramp to the weight on each wheel. The MaxxHaul states 2,200 lb per ramp; the VEVOR listing does not state a per-ramp figure, so confirm it first.
- Check the floor space. A 48.8 in ramp needs a longer run of clear floor than a 27 in ramp, and the VEVOR needs fixings, with pre-drilled holes and expansion screws listed.
Never get under a vehicle supported only by a jack. Use rated stands on solid, level ground, and follow the owner’s manual lift points and the ramp maker’s instructions before working underneath.
Check the lift's rated capacity against your heaviest vehicle, and its ceiling and concrete requirements (thickness and strength) before you buy. Install it exactly as the manufacturer specifies, use the mechanical locks before you go under, and look for ALI certification on the model. See the Automotive Lift Institute (ALI). Read our Safety Disclaimer.
Car Ramps Sized for the Job
Each ramp here is sized for a different measurement problem: the VEVOR bridges a step and the MaxxHaul lifts a car for maintenance, so pick the ramp whose dimensions match the job.
FAQ: garage tools
What size car ramp do I need for an oil change?
For routine maintenance, a low-profile ramp such as the MaxxHaul 50516, 27 in long with a 2.5 in maximum lift height and a 9.05 degree loading angle, is the shape the maker lists for the job. Check the lift height against the clearance the job needs and the 4,400 lb capacity against the car’s weight, and never work under a car supported only by a jack.
How wide should a car ramp be?
Wide enough for the tyre to sit on the ramp: the VEVOR curb ramp is 16.1 in wide, while the MaxxHaul is 7-3/4 in wide, so compare the tyre width with the ramp width before buying.
What is the loading angle on a car ramp?
The loading angle is the slope the car climbs, and a lower angle suits a lower car. The MaxxHaul lists a 9.05 degree loading angle for low-clearance cars. The VEVOR listing does not state a loading angle.
How much weight can a car ramp hold?
It depends on the ramp: the MaxxHaul is rated at 4,400 lb, or 2,200 lb per ramp, while the VEVOR title states 33,000 lb and its bullets state 15 tons. Use the per-ramp figure against the weight on each wheel where the listing states one; the VEVOR listing does not state a per-ramp figure, so confirm it before loading a heavy vehicle.
Are curb ramps the same as car ramps?
No. A curb ramp such as the VEVOR, 48.8 in long with a 2.6 in rise, is built to bridge a curb or threshold for cars, RVs and wheelchairs. A maintenance ramp such as the MaxxHaul lifts the car 2.5 in for routine work underneath. Match the ramp type to the job, not just the size.
Related: car ramp dimensions and lifting gear, the best car ramps under 50, low profile car ramps and car ramps vs bottle jack.
