QuickJack 6000TLX Review: Specs, Pros, Cons and Who It Suits
A research-based look at the QuickJack 6000TLX portable lift: 6,000 lb capacity, 24 in max height, 110V power, what it does well and who should skip it.
On this page
This QuickJack 6000TLX review comes down to one point: the 6000TLX is a good fit for a home mechanic who wants the whole car off the ground, level, for wheels, brakes, suspension and detailing work in a garage with a normal ceiling, and who does not need to stand under the car. It lifts up to 6,000 lb to a listed 24 in maximum height on a 110V power unit, then the frames come back out and store flat. We have not used the lift ourselves; this review is based on BendPak’s Amazon listing for the 6000TLX and the specs published there.
As an Amazon Associate I earn from qualifying purchases. GarageToolHQ earns a commission when you buy through links on this page, at no extra cost to you. Read our affiliate disclosure.
QuickJack 6000TLX Portable Car Lift
A 6,000 lb portable car lift with extended 70 in frames, a 24 in maximum height, automatic locks and a 110V power unit, stored flat when not in use.
Pros
- Lifts both sides at once to a 24 in maximum height
- No anchors, no ceiling limit, runs from a 110V outlet
- 37 to 60 in lift point spread for longer wheelbases
- Frames lower to 3 in and store against a wall
Cons
- 24 in is a creeper-height lift, not stand-up
- No ALI certification stated on the listing
- 1 year warranty stated
- Very low cars may need ramps to fit the frames
QuickJack 6000TLX review: the short verdict
QuickJack is BendPak’s portable lift line. A QuickJack is two low steel frames that you slide under the sides of the car, a hydraulic power unit, and hoses. Press the button and both frames scissor up, lifting the car by its lift points. The 6000TLX is the 6,000 lb version with the extended frames the listing says suit trucks, SUVs and longer-wheelbase vehicles.
The appeal is simple: no bolts, no concrete anchors, no ceiling problem, and the car comes up evenly on both sides instead of one corner at a time. The limits are just as clear. Two feet of height is a crawl-under lift, not a walk-under lift, and the listing we read states a 1 year warranty and does not state ALI certification for this model.
Key specs
| Spec | QuickJack 6000TLX |
|---|---|
| Capacity | 6,000 lb |
| Max height | 24 in |
| Lowered height (frame only) | 3 in |
| Lift point spread | 37 to 60 in |
| Frame size | 70 x 11 in |
| Frame weight | 78 lb |
| Power unit | 110V, 15 lb |
| Locks | Automatic, engage while lifting |
| ALI certified | Not stated |
| Warranty | 1 year |
Specifications are manufacturer rated, as published on the Amazon listing and collected 6 October 2026. The listing’s shipping weight is 296 lb; the frame and power unit weights above are the figures it gives for the parts you actually move around.
The lift
What the 6000TLX does well
No install, no ceiling question
A 2-post or 4-post lift is a construction project: slab thickness, anchors, a tall ceiling and often a 240V circuit. The 6000TLX needs none of that. It runs from a 110V power unit, does not bolt down, and at a 24 in maximum height it fits under almost any residential garage ceiling. Our car lift ceiling height calculator shows why: a 70 in tall SUV raised about 16 in off its parked position, plus 3 in of clearance, needs roughly 89 in of ceiling. A standard 8 ft garage has 96 in.
The whole car up, level
With a floor jack and stands you lift one corner or one end at a time, and the car sits at whatever angle the stands allow. The QuickJack raises both sides together on two frames, so all four wheels come off the ground at once. For a tire rotation, a brake job on all four corners, a suspension refresh or a full detail of the wheel wells, that saves a lot of jacking and re-jacking.
Locks that set as it rises
The listing describes a built-in locking system that engages automatically as the frames go up. The point of mechanical locks is that the car rests on steel, not on hydraulic pressure, once you lower onto them. That is the state the car should be in before any part of you goes underneath.
It leaves the garage when you are done
BendPak lists the frames at 78 lb and the power unit at 15 lb. Each frame is 70 in long and 11 in wide and lowers to 3 in, so the set can lean against a wall or slide under a workbench. If your garage also has to hold the daily driver, that matters more than any lift spec.
Long frames for longer vehicles
The listing gives a lift point spread of 37 to 60 in, the range between the front and rear lifting blocks on each frame. Your vehicle’s front and rear lift points on each side need to fall inside that range. The extended frames are the reason the listing pitches the 6000TLX at trucks, SUVs and longer wheelbases.
Limitations
- Height. At 24 in maximum, you work on a creeper, not on your feet. Exhaust, transmission and fuel tank work is possible but cramped. If that is most of your work, look at a mid-rise or full-rise lift.
- Center access depends on the car. The frames sit along the sides, so the center is open, but the frames and blocks take up the rocker area. Jobs on the pinch welds or rockers themselves need a different lift point.
- Low cars need room to start. The frames lower to 3 in, and the lifting blocks add height on top. A slammed car may need to roll up on low ramps first. Measure your clearance at the lift points before you buy.
- Warranty and certification. The listing states a 1 year warranty and says nothing about ALI certification for this model. Our Shop Score gives no safety points when a listing does not state a certification, which is why the 6000TLX scores lower than its reputation might suggest.
- Thin listing. The listing is new and carries only a handful of ratings, so there is not yet much owner feedback specific to this model.
How we scored it
Shop Score weighs performance, build, value, safety and warranty. Full method on our how we pick page.
| Product | Shop Score | Perf. /35 | Build /25 | Value /25 | Safety /10 | Warranty /5 |
|---|---|---|---|---|---|---|
| QuickJack 6000TLX | 9.5 | 30 | 22 | 20 | 0 | 2 |
Scores run from 9.2 to 9.8: each product’s point total is placed on that range, so more points always means a higher score.
Who should buy the QuickJack 6000TLX, and who should skip it
Buy it if
- Your garage ceiling is too low for a 2-post or 4-post lift, or you rent and cannot anchor anything.
- You do wheels, brakes, suspension, fluids and detailing more than exhaust or transmission work.
- You drive a truck, SUV or long-wheelbase car whose lift points sit 37 to 60 in apart.
- You want the lift out of the way when it is not in use.
Skip it if
- You want to stand under the car. Look at a full-rise lift in our best car lift for home garage picks, or the 2-post vs 4-post lift comparison.
- You want more height without a tall ceiling: the 48 in mid-rise scissor lifts in our best car lift for low ceiling guide sit between the QuickJack and a full-rise lift.
- ALI certification stated on the listing is a must for you.
- You lift one end at a time for oil changes. A good jack and rated stands cost far less.
Alternatives
- Jack and stands: for occasional one-corner jobs, a low-profile floor jack plus a pair of the best jack stands covers most of what a weekend mechanic needs.
- Mid-rise scissor lift: more working height, still no overhead beam, but heavier and not something you lean against a wall.
- 2-post or 4-post lift: stand-up access and storage over the car, if your ceiling and slab allow. Check both with the ceiling height calculator first.
Check the ceiling a lift needs for your car, and whether 2-post, 4-post, mid-rise or scissor fits.
Check the lift's rated capacity against your heaviest vehicle, and its ceiling and concrete requirements (thickness and strength) before you buy. Install it exactly as the manufacturer specifies, use the mechanical locks before you go under, and look for ALI certification on the model. See the Automotive Lift Institute (ALI). Read our Safety Disclaimer.
Whatever lift you use: put it on solid, level ground, place the blocks at the lift points in the vehicle’s owner’s manual, lower onto the mechanical locks before going under, and never work under a vehicle held only by a jack. Read the lift’s manual for its surface requirements before the first lift.
Frequently Asked Questions
How high does the QuickJack 6000TLX lift?
The listing gives a maximum height of 24 in and a lowered frame height of 3 in. How far your tires leave the floor depends on how high your lift points sit when the car is parked.
Does the QuickJack 6000TLX need a 220V outlet?
No. The listing specifies a 110V power unit, so it runs from a standard household outlet. Check the manual for the circuit it recommends.
Can I use the 6000TLX on a truck or SUV?
The listing pitches it at trucks, SUVs and extended-wheelbase vehicles. Check two things: the vehicle’s weight is within 6,000 lb, and its front and rear lift points on each side are 37 to 60 in apart.
Is the QuickJack 6000TLX ALI certified?
The Amazon listing for the 6000TLX does not state ALI certification. If that matters to you, confirm it with BendPak before buying, and look for the ALI gold label on the product.
Do I still need jack stands with a QuickJack?
The listing says the open center allows work without jack stands. The non-negotiable part is that the lift is lowered onto its mechanical locks before you go under, on a solid level surface, with the blocks at the vehicle’s lift points as the manual describes.
Related: the best car lifts for a low ceiling, the best car lifts for a home garage, 2-post vs 4-post lift, our car lift hub and the car lift ceiling height calculator.
